Jiaozuo ribs multifunction steaming cabinet manufacturers 15,065,231,771 1. Install installation method must see before wiring nameplate voltage, and you must install the GFCI, power lines yellow and green lines must be firmly connected in full compliance with safety required protective earthing line; forbidden to yellow-green wire connected to the water pipes or gas pipes. 2. Place the machine placed in a smooth, dry and ventilated place to place, the cavity clean before and after use. 3. When the first time, a series of good water inlet pipe (the lower part of the body-side end labeled with the intake air inlet and pressure relief valve), check the float valve inlet to normal, the valve is normally open state, put steaming plate the shelves, and through the water valve to automatically open the valve, the heating temperature steam sterilization for 30 minutes after steaming food preparation. 4. The use of electric heating steaming food: steaming food: after turning the water supply, water tank filled with water, first preheat until after boiling the water tank to generate steam, and then disconnect the power guillotine slowly Open the door and let the car steaming hot steam relief, relief and then opened the door and put the food to be steamed, closed the door and locked, continue ohmic heating. Relief extract: to be shut down after being steamed food cooked power or steam valve, (depending on whether you need food steaming stew decide whether to take out immediately), should pay attention to the body must not remove the food is on steam rice car and the door should be made on the body side door to avoid as far as possible away from the steaming car door and slowly opened the door and let the car steaming hot steam relief food after removing the door, remove the food when It should be noted anti-scald, recommended to wear gloves or using jigs extract. When using an external steam steaming food (first connect the power of the knife off, turn off all into the drainage valve). Steamed food: After the steam source access the lower "steam inlet", slowly open the steam valves, pressure gauges inside the observation meets the requirements to ensure that the vapor pressure of the input does not exceed 0.02Mpa, first preheat until there After exclusion of steam, steaming food preparation, before the door into the food, you should turn off the steam valve, slowly open the door, let the steaming hot steam relief after the car to open the door into the food to be steamed, close the door handle and lock, and then slowly open the steam valve and continue steaming. Relief extract: First, turn off the steam valve, then extract relief. (Relief extract rules with electric heating same order). Native non-high-pressure sealed container, a small amount of steam is normal overflow from the door. Tel: 15065231771 Wang QQ: 3152855840 Company Website: http: //zpyangyongtzsb.1688.com/ http://www.shandongyangyong.com/ Address: Binzhou City, Shandong Province Economic Development Zone, Zouping County town tomorrow